So my question now is how can i proceed with the learning. I have gone to the Broadcom website and there are adapter cards meant for servers and clients, so my thinking is since mine is falling under clients maybe its not supported by server 2012. Complete the configuration before you proceed" The TCP/IP networking protocol must be properly configured. This release should be used with the Broadcom NetXtreme-E 21.8.1 device drivers. "Verification for domain controller promotion failed. This release provides updated network controller firmware for the Broadcom NetXtreme-E devices. I have also tried to install the DNS server role firstĪs u suggested before installing AD, but I still get the same results after running the command: Test-ADDSForestInstallation ![]() "You need to appropriately configure TCP/IP settings, including DNS server addresses"Īs I understand one can test TCP/IP settings by pinging the 127.0.0.1, which obviously will not happen as the network adapter card hasnt been configured with an IP address as there are no drivers. Driver Network Controller Win 8 1 64 Bit free download - ATI Catalyst Software Suite (Windows 7 64-bit / Windows 8 64-bit / Windows 8.1 64-bit), Realtek High Definition Audio Codec (Windows 7 / 8. However for a server to be configured as a DC there are several prerequisites that it must meet one ![]() ![]() According to the book you dont need to configure the server as a DNS first you can have the DNS role installed during the promotion of the server to a DC.
0 Comments
Leave a Reply. |